Mustang Precut Stripe Locator Sheet

 

For Mustangs and GT’s For Model Years 2005-2009

 

1. Front fascia piece for the cdc chin spoiler

 -Can be used on other styles including some stock chin fascia’s

2. Chin Fascia Piece for the v6 and other models

3. Lower Front Bumper Piece for Models that do not have a front plate cut out

4. Upper Front bumper piece for all models

5. Hood Pieces with washer nozzle cut outs

6. Roof Stripes

7. Trunk or Rear Deck

8. Third Brake Stripes

9. Faux Gap Cap Stripes

10. Rear Bumper Stripes

11. Stripes for optional stock spoiler

12. Pieces for lower front bumper to go around license cutout area

13. 2008 Model Bumper Stripes

14. 2008 Model Bumper/Spoiler Stripes

15. Front License Plate area

 

• We have now attached the trunk and third brake light piece for those who prefer to apply these pieces together. The separate trunk and third brake light pieces are still include for those with a Roush Spoiler. The spoiler piece has been lengthening to fit the Roush Spoiler. Simply cut off the excess on the non Roush spoilers. You will also have the windshield washer cutouts on the hood stripe.
• 2” gap between stripes is recommended
• It is best to apply the stripes on a warmer day or in a garage with heat. In excessive heat, the stripes will dry to fast. Try to avoid direct sunlight until stripes are squeegeed in place.
• Be sure to wash your car with a sponge and remove all the dirt.
• Always use a felt squeegee to avoid scratching the stripes.
• After peeling away the wax backing, spray both the surface of the vehicle and the back of the vinyl stripes with a soapy solution. Then slide the decal into position and squeegee out the bubbles.
• Do not use a car wash that uses spinning brushes. These can damage the stripes.
• Avoid waxing any type of matte stripes.
• There are two sets of front bumper sets in your kit. One is for bumpers with the license plate cutout, the other is for the bumpers without this cutout.
• The rear deck is in 3 pieces, this was the only way to ensure that the average person could do this job. Place the pieces that surrounds the emblem first, allow to dry then apply the other 2, with a slight overlap. No one will see it when you are done. They are carefully cut in places to avoid being in the field of view.

 

When you are done, please send us pictures to: Customerrides@jerseyautoparts.com

We would love to show case them in our galleries.